 Decorator
fields, such as holes, are used by metal tag printers that can have holes. Holes
are punched in the metal tag substrate and are typically used to affix the tag
using nails or wire. Holes are decorator fields and are only shown in the
designer as an aid in placing other fields, but are not printed.
|
|
The Hole tool is used to add a hole decorator field to the layout. A layout may have an unlimited number of hole fields, but it may not be possible to manufacture such a tag. Contact the factory for assistance. |
|
Once the field is added to the layout, you use the Properties Editor to change the field's properties.  Each
hole field is defined by several pieces of information that you must supply.
This information includes:
Diameter The diameter of the hole in inches or millimeters. X The X coordinate of the center of the hole. This field was initially filled in for you based on where you clicked the mouse. Y The Y coordinate of the center of the hole. This field was initially filled in for you based on where you clicked the mouse. |